Assembly Instructions for Kaido House OFFSE7 Pin Cases

Important Notes:
Please consider these instructions a general guide for assembly; you may find additional tips or steps to help you. So you do not have to strictly follow the guide below.   

Consider using gloves during assembly to prevent fingerprints if desired.

Step 1: Lay out the acrylic panels
Keep the protective paper film on the acrylic, lay out all the acrylic panels on a clean surface, making sure they are positioned for easy identification.

Step 2: Start with the Bottom Panel
To begin, take the bottom panel and position it with the sticker facing up. Peel off the protective film that has the sticker on it; leave the bottom film for now.
  

Step 3: Assemble the Front, Back, Left, and Right Panels
Next, remove the paper film from the front, back, and side panels. Then, assemble the side panels to the front and back panels, ensuring that the KR logos are on the inside of the front or back panel and facing outwards. The actual engraving will be on the insides of the side panels. Then set all 4 panels onto the bottom panel by aligning the holes and tabs.
  

Step 4: Flip the Case Over
Holding the panels together, carefully flip the bottom panel over and insert the nut and screw on each side to attach it to the side panels.

Securing the panels together with hardware
Using the acrylic nuts and stainless screws provided, insert one nut into the hole in one of the side panels. While holding the nut in place, insert a screw into the screw hole above and start threading it into the nut by hand to get it started. Then snug the screw down with the provided hex wrench. DO NOT OVERTIGHTEN!!!

Repeat this process on the opposite side.

Step 5: Securing the panels together with hardware
After securely holding the bottom panel in place, carefully flip the display back over.

Step 6: Add your Pin!
Carefully slide your Kaido Pin down into the slots of each nut at the bottom to hold the pin in place.

Step 8: Finishing the Top 
Remove the protective film from the underside of the top panel. Insert a nut into the top of each side panel, aligning the pin card with the slots of each nut. Be sure the nuts stay in place (the tricky part), and place the top panel on top of the other panels. Then insert the screws on each side and fasten the top panel into place. Then remove any remaining protective film and take a moment to appreciate your work! Your acrylic display is now ready to show off your Pin.

Cleaning Notes:
Avoid Windex or other harsh chemicals. Opt for an acrylic cleaner or soap and water to maintain the display's appearance. Use soft cloths, such as microfiber, for cleaning, avoiding paper towels.

Step 9: Share your creation
Share photos of your built acrylic display on social media or with friends to present your collectible showpiece with style!

PS: Be sure to tag us so we can see it too!!!

Facebook / Instagram / Tiktok

@kreativerides

THANK YOU FOR YOUR SUPPORT!!