Diecast Box Style Dual Display Assembly Instructions

PRO TIP: Try a test assembly before peeling the protective paper. You do not need to screw it together for the test; this way, you can learn how the panels go together before you start final assembly. Consider using gloves during assembly to prevent fingerprints.

Step 1: Lay out the acrylic panels
Keep the protective paper film on the acrylic, lay out all the acrylic panels on a clean surface, making sure they are positioned for easy identification.

Step 2: Start with the bottom 
To begin, take the bottom panel and position it with the sticker facing up. Peel off the top protective film.

Step 3: Place the back
To begin, take the back panel and position it with the sticker facing forward. Peel off the protective film from both sides and place the panel into the rear holes of the bottom panel. You can let it lean forward so it will stand up for now.

Step 4: Placing the side walls
Next, remove the paper film from the side panels (Left & Right). Then, assemble the side panels to the back panel, ensuring that the KR logos are on the top side of the side panels and facing outwards. The actual engraving will be on the insides of the side panels.

Step 5: Placing the Center Divider
Remove the protective film from the center divider panel and place it in the center of the bottom panel by aligning the tabs and holes. Make sure the rear tab is placed into the back panel at the top. 

Step 6: Placing the Top Panel
Remove the protective film from the bottom of the top panel, then place it on top of the other panels, aligning the tabs and holes. 

Step 7: Securing the panels together with hardware
Using the acrylic nuts and stainless screws provided, insert one of the nuts into the hole on the center panel. While holding the nut in place, insert a screw into the screw hole above and start threading into the nut by hand to get it started. Then snug the screw down with the provided hex wrench. DO NOT OVER TIGHTEN!!!

After securely holding the bottom panel in place, carefully flip the display over. 

Repeat this process on the left and right sides. DO NOT OVER TIGHTEN!!!

PRO TIP: Do the outer 4 nuts and bolts first. Then turn the display on it side and do the center nuts and screws. It makes it easier to place the nuts into the holes.

Step 8: Adding the Carded Diecast
Add one of your carded diecast and secure it with 3 of the slide-in clips, two clips on the outer side, and one clip in the bottom hole of the center panel. 
Add the second carded diecast on the opposite side and secure it with 3 more slide-in clips, two on the outer side and one in the top hole in the center panel. 

Step 9: Add Front Panel
Loosen the top screws just enough to insert the front panel into the opening. You can test fit before removing the protective film. Then remove the protective film and attach the front panel to the bottom panel by aligning the tabs and holes, then into the holes in the top panel. Once you have the tabs and holes all aligned, you can tighten the screw back down, and you are done!

Step 10: Enjoy your finished display
Take a moment to appreciate your work! Your acrylic box display is now ready to show off your items.

Cleaning Notes:
Avoid Windex or other harsh chemicals. Opt for an acrylic cleaner or soap and water to maintain the display's appearance. Use soft cloths, such as microfiber, for cleaning, avoiding paper towels. ALWAYS spray the towel, not the display directly!!!

Step 11 (optional): Share your creation
Share photos of your built acrylic box display on social media or with friends to showcase your collectible showpiece in style!

PS: Be sure to tag us so we can see it too!!!

Facebook / Instagram / Tiktok

@kreativerides

Video Example of Assembly